Disposal emergencies and why a disposal stops working
| Symptom | Likely cause | Typical fix |
|---|---|---|
| Hums but will not spin | Jam from a hard object or buildup | Free the flywheel with the hex key at the bottom |
| Nothing happens | Tripped reset button or breaker | Reset, then test the switch |
| Leaks from the bottom | Failed seal | Replace the unit |
| Leaks at the top or sides | Loose flange or drain connection | Reseal or tighten |
| Smells | Food residue in the chamber | Clean and flush |
A leak from the body of the disposal means the unit has failed. Seals inside cannot be replaced in the field, so replacement is the answer.
What not to put down the disposal
- Grease, oil and fat, which cool and coat the drain pipe.
- Coffee grounds in quantity, which pack into a sludge.
- Fibrous foods like celery, corn husks and artichoke leaves.
- Pasta, rice and potato peels in large amounts, which swell.
- Bones, fruit pits and anything hard.
A disposal is not a trash can. The unit grinds soft food in small amounts with cold water running. Most disposal clogs begin in the drain pipe, not the unit, which is where drain cleaning comes in.
Choosing a replacement
Disposals are rated by horsepower. A half-horsepower unit suits a small household, while three-quarters to one horsepower handles heavier use. Higher-end units have sound insulation and stainless grinding parts that last longer.
Most disposals plug into a dedicated outlet or hardwire to a switch. If there is no electrical connection under the sink, we coordinate with an electrician. Tell us when you call.
Kitchen disposal acting up?
A short visit usually sorts it out.
Installation steps
- 1
Disconnect power
We switch off the circuit and remove the old unit and mounting.
- 2
Mount the new unit
The flange is sealed with plumber's putty and the disposal is locked into the mount.
- 3
Connect drain and dishwasher
The drain pipe and dishwasher inlet are connected, and the knockout plug is removed if a dishwasher is attached.
- 4
Test
We run water and the disposal, and check for leaks below.
Keeping a disposal running longer
Run cold water before, during and for about fifteen seconds after grinding. Cold water keeps fats solid so they break up and wash through, where hot water melts them and lets them coat the pipe. Feed small amounts at a time rather than a heap.
Clean it by grinding a handful of ice and a few citrus rinds now and then. Do not use harsh chemicals, which can damage seals. If the unit smells even after cleaning, the buildup is probably in the pipe below, not the grinding chamber.
Noise, vibration and warranties
A new disposal is quieter than an old one, but a loud rattle often means a spoon or bottle cap in the chamber. Turn off power and remove it with tongs, never your hand. Most disposals carry a manufacturer warranty, so keep the receipt and the model number.
Electrical and plumbing standards
A disposal is both a plumbing and an electrical appliance. The drain and trap follow New Jersey's plumbing subcode, N.J.A.C. 5:23-3.15, and a hardwired connection follows the National Electrical Code (NEC). Where we are not the right trade for the wiring, we tell you and coordinate an electrician.
What affects the price of disposal work
- Repair or replacement. A jam is cheaper than a new unit.
- Unit size and quality. Horsepower and features vary the price.
- Electrical needs. A missing outlet or switch adds work.
- Drain condition. A clogged line beyond the disposal needs separate work.
- Old sink flange. A corroded flange may need replacing.
You get a clear price before work starts. Call (856) 250-1784 for your number.
Kitchens in older Bridgeton homes
A disposal on an old drain line is a recipe for repeat clogs. A kitchen drain with a long run lets grease build up. If your disposal keeps backing up, a camera or hydro jetting visit may help more than another unit.
Garbage Disposal Repair questions in Bridgeton, NJ
Yes. A disposal leaking under the sink or jammed with water standing in the basin is dispatched around the clock. Switch off the power first, and keep your hand out of the unit.
It is jammed. Turn off power, use the hex key in the bottom socket to free the flywheel, and press the reset button.
Usually yes, if there is power and the drain is compatible. We check both.
Many last roughly a decade, depending on use and quality.
Many septic owners avoid heavy disposal use. Ask your septic contractor before installing one.
The drain beyond the disposal is partially blocked. We clear the line.
A like-for-like swap is generally maintenance. Ask the Bridgeton construction office if you are changing the piping.
Need a disposal repaired or installed?
Call to book in Bridgeton.
